Brought to you by www.buildahottub.com, this super-slim, 35W RGBW colour changing LED pool and hot tub light is the only underwater light source you need for your DIY Build. At just 8mm (0.31″) thin in the centre, and 2-3mm on the outside edge, this underwater LED light has a “barely-there” footprint.
It is also surface mounted for your convenience making the install as easy as can be!
Say Hello the the thinnest surface mount under water LED on the market!
When you are building that Hot Tub or Pool of your dreams, the last thing you need is a big, clunky, ugly underwater halogen light. Luckily, these are now a thing of the past with our super-slim resin filled 230mm colour changing beauty.
buy now
Low voltage 12V DC power supply
Only 8mm thin, it’s barely-there
IP68 rated underwater LED
At 35W, there is some serious power from this super-thin light
Resin-filled for superior water-proofing
Full spectrum of light with Red, Green, Blue and dedicated White LEDs
Just connect to a 12V DC power supply (not included) to this unit and the controller will do the rest. Operate the remote control (not waterproof) from 15m /50ft. Have more than one light? No problem. The controllers automatically sync allowing you to change the lights at the same time from a single remote control.
26cm x 26cm x 7cm – 1.6kg
10.24″ x 10.24″ x 2.76″ – 5.53lbs
HS Code – 94054090000
With the help of the buildahottub.com connection kit, this is the only pool grade light that can plug into a spa pack and not blower your fuse! Specifically designed to plug straight into your Spa Pack so you can use the light button on your topside controller, this innovative bit of kit comes as standard with the buildahottub.com light.
www.buildahottub.com LED Controllers will automatically transmit the signal to other controllers simultaneously within a 30m (98ft)range. This allows you to expand the distance between the first and last light to over 100m (328ft). This is twice the size of an Olympic swimming pool!
Before beginning process, make sure plastic battery protector has been removed. You can check by pressing the power button on the remote control. You should see a red light indicating the remote has power. If not, remove the plastic battery protector and insert battery.
Step 1 – Power On LED Controller from 12V DV Power Supply.
Step 2 – Press the “match” button on the LED Controller
Step 3 – Rapid press the On/Off button until the LED flashes.
Step 3 – Use on/off button to test connection with LED light.
If connection has not been made, power off LED controller at 12V DV supply and repeat process
Please note, to un-pair a Remote Control from the LED controller, power on the LED controller and press and hold down the “Mode” button on the LED Controller for 5 Seconds. This will remove the connection to the Remote Control.
Lorem ipsum dolor sit amet, consectetuer adipiscing elit, sed diam nonummy nibh euismod .
Our blog
Recently, a client of mine, Chris, embarked on a journey to upgrade his 7-year-old hot [...]
In this article, I’ll take you through how to control the air source heat pump [...]
Choosing a new pool pump can seem overwhelming, by the end of this article, you’ll [...]
Explore this stunning DIY hot tub build case study in Utah, featuring expert tips on [...]
One of the most common questions I get, probably on a weekly basis, is: How [...]
By using an air source heat pump, I was able to significantly reduce the electricity [...]
One of the most frequent questions I get is what's the best budget-friendly DIY hot [...]
